Bridging $TREAD to HyperCore
Your $TREAD genesis allocation is delivered to the address you submitted when you accepted the Genesis Distribution Terms.
Eligibility
You must have registered and accepted the Genesis Distribution Terms at app.tread.fi/points to receive a $TREAD allocation. The deadline was September 15, 2026 at 9:00 AM EDT.
How to bridge
Click the $TREAD icon on on the top right to see your $TREAD Holdings
Click Bridge $TREAD
Set From to Ethereum.
Set To to HyperCore.
Enter the amount of $TREAD to bridge. Click Max to bridge your full balance.
Review the Estimated network cost. This is the gas fee for the transaction. It appears after you connect your wallet.
Click Bridge. Confirm the transaction in your wallet.
Wait for the transfer to complete. This takes around 10 minutes.
Troubleshooting
My transfer is taking longer than 10 minutes. Ethereum congestion can delay confirmation. Check the transaction hash on Etherscan. If the Ethereum transaction has confirmed and $TREAD has not arrived after 30 minutes, contact support by creating a ticket on our official Discord
My transaction failed. Make sure your Tread wallet holds enough ETH for gas.
The bridge says I have insufficient funds. Your Tread wallet does not have enough ETH to pay gas. Deposit ETH to your Tread wallet address and try again.
I did not receive an allocation. Allocations only went to users who accepted the Genesis Distribution Terms before September 15, 2026 at 9:00 AM EDT. There are no exceptions.
I do not see $TREAD on Hyperliquid. Check that you are viewing the same address you bridged to. Check your spot balance, not your perps balance.
This page is for informational purposes only. It does not constitute investment advice or an offer to sell or a solicitation to buy any asset.
Last updated
Was this helpful?